Surefire 6P Switch Mod

I bought a Surefire 6P to house my Malkoff Devices M60 drop-in. You have to be kind of a flashaholic to understand that sentence.

Surefire describes the 6P as a “Compact (pocket sized), high-intensity incandescent flashlight for tactical, self-defense, and general use. (It) produces a smooth, brilliant, pre-focused tactical-level beam with three times the light of a big two-D-cell flashlight.”

The 6P’s stock lamp assembly is a P60 incandescent lamp. You can stop right there and you have a great flashlight that puts out 65 lumens.

The Malkoff Devices M60 drop-in (now replaced by the M61 with a Cree XP-G) uses a Cree XLamp XR-E LED (Q5 bin) as a replacement for the incandescent lamp. In addition to being more rugged, it puts out 235+ lumens. Gene Malkoff, the creator of the M60 says, “It will easily illuminate objects at 350+ feet and will blind opponents within a 100 foot radius.” That’s what we want.

Naturally, when I get something new, I take it apart and think about how to mod it. My new Surefire’s switch seemed like a good candidate.

The Surefire Z41 tailcap is standard on the 6P. It has a momentary option by pushing the tailcap switch. Rotating the tailcap will turn on the light for constant operation.

Most of my flashlights use a forward clicky switch. A slight press of the switch (before it clicks), will momentarily turn on the light and a full press (when the switch clicks), will latch it on. I’ve put the McClicky switch in seven or eight of my flashlights and thought it would work well in the Surefire 6P. I could have bought a Surefire Z59 Click-on Tailcap Switch or the Oveready McClicky Kit for USD $22, but it’s more satisfying making my own.

I yanked out the insides of the existing switch and unscrewed the retaining ring. Sometimes the retaining ring is glued. I’ve put the tailcap in a ziplock bag and boiled it hot water for five minutes and the glue will release.

Since I only had a plastic retaining ring to hold in the new switch, I soldered a piece of brass to the McClicky switch so that it contacts the inside of the switch housing. I put a dab of solder on the contact on the other side so the retaining ring would seat the switch flat inside the tailcap.

If you have an aluminum or brass retaining ring, there is no need to solder a tab – just screw it in. You must be careful about the inner part of the retaining ring contacting the positive connection on the raised plastic below the contact spring – it will short out the switch and be “on” all the time. A piece of shrink tubing or electrical tape wrapped around it will prevent a short.

Using that piece of brass also meant I had to remove the anodizing from the inside of the housing so the brass tab makes electrical contact with the side of the tailcap. With one mod that I did, I lost the lock out function, which “prevents accidental activation of light during tactical engagements, transportation, or storage,” according to Surefire. On another mod, the lock out still worked. In my case, I’m very unlikely to have a tactical engagement, so I can remove the batteries for transportation and storage.

To bottom it off, I replaced the black rubber push button cover with a Glow-in-the-Dark Silicone Tailcap…maybe a not too tactical feature.